| Safety Warnings |
|
>
|
All personnel should be alerted to the potential hazards indicated by
the product safety labeling on this unit. |
|
>
|
The following conventions are used to indicate and classify precautions
and on product safety labeling. Failure to observe precautions could
result in injury to people or damage to property. |
 |
This
is the safety alert symbol. It is used to alert you to potential
personal injury hazards. Obey all safety messages that follow this
symbol to avoid possible injury or death. |
 |
Danger indicates an imminently hazardous
situation, which, if not avoided, will result in death or serious
injury. |
 |
Warning
indicates a potentially hazardous situation, which, if not avoided,
could result in death or serious injury. |
 |
Caution indicates a potentially hazardous
situation, which, if not avoided, may result in minor or moderate
injury. |
 |
Caution used without the safety alert symbol
indicates a potentially hazardous situation, which, if not avoided, may
result in property damage. |
|
 |
This symbol/pictorial is used to identify an
ELECTRICAL SHOCK or ELECTROCUTION hazard. |
 |
This symbol/pictorial is used to identify an
ULTRAVIOLET LIGHT hazard. |
|
>
|
Product safety labels should be periodically inspected and cleaned, as
necessary, to maintain good legibility. Always replace illegible safety
labels. Contact factory to obtain replacement safety labels. |
|
Safety Instructions |
| WARNING: To guard against injury, basic safety
precautions should be observed, including the following: |
| 1. |
Read and save all notices, warnings and safety instructions received
with equipment. |
| 2. |
 WARNING: Avoid exposure to direct or
strongly reflected germicidal ultraviolet rays. Germicidal ultraviolet
rays are harmful to the eyes and skin. |
| 3. |
WARNING: Always disconnect power, to
the equipment and unplug, before performing any service or maintenance. |
| 4. |
CAUTION: Do not operate without proper
electrical ground. |
| 5. |
DANGER: To prevent the risk of severe
or fatal electrical shock, special precautions must be taken. Water
purifiers should be plugged into an approved Ground Fault Circuit
Interrupt (GFCI) receptacle. |
| 6. |
Intended for indoor use only. |
| 7. |
Do
not alter the construction or design. Do not remove safety labels or
devices |
| 8. |
Do
not use this equipment for other than its intended purpose, as
described in the equipment manual. |
| 9. |
On
equipment with blowers keep inlet and outlet vents, clean and clear of
objects. |
| 10. |
CAUTION: Germicidal ultraviolet rays may break down
plastic, rubber or other non-metallic materials, can fade colors and
can be damaging to plant life. Shield all plastic, rubber or other
non-metallic parts, plant life, etc. which may be exposed to direct or
reflected germicidal ultraviolet rays. |
| 11. |
Do
not operate the unit if the power cord and/or plug are damaged, or if
any other damage to the unit is visible or suspected. |
| 12. |
Utility power must match power requirements listed on the unit label. |
| 13. |
Water purifiers should be protected from the elements and from
temperatures below freezing. |
| 14. |
Do
not exceed water purifier’s maximum rated flow capacity and
or operating pressure of 100 PSI. |
